The Lezyne E-Bike Rear Fender comes with a StVZO-optimized lens from Germany, which offers a wide light spread. Two high-powered LEDs deliver 11 lumens of brightness. This light is IPX7 water-resistant and includes a Composite Matrix fender mounting system. It's e-bike compatible (works with 6v input at 0.6w or 12v input at 1.2w) and can be easily plugged into motors from top brands like Bosch, Shimano, and Yamaha. The package includes stainless Allen key hardware and a 130cm long power cable. Our e-bike lights are powered by the e-bike's motor or battery and need manual installation. Installing may involve disassembling parts of the bike and motor (depending on the make, model, and battery type) and adding extra wiring to connect the light to the motor. Reach out to the e-bike or motor manufacturer for installation instructions. It's strongly advised to have a trained e-bike expert install the lights for you.
Using this Lezyne e-bike rear fender with light is quite straightforward. First, you'll need to connect it to your e - bike's motor. The power cable is 130cm long, so it should reach easily. Just plug it into motors from well - known brands like Bosch, Shimano, and Yamaha. But remember, this is a manual installation. You might have to take apart some parts of your bike and motor, depending on the make, model, and battery type. It's a good idea to get in touch with your e - bike or motor manufacturer for specific installation steps. If you're not confident, have a trained e - bike professional do the installation. As for maintenance, since it's IPX7 water - resistant, it can handle a bit of water splashing. However, try to keep it dry as much as possible. If it gets dirty, use a soft cloth to clean it. And always check the connection between the light and the motor regularly to make sure it's working properly.
